Guides / Design

QR codes with a logo

You can put a logo in the middle of a QR code because error correction rebuilds the dots it covers. Use error correction H, keep the logo under about a quarter of the code's width, and leave the corner squares alone.

2 min readDesign
On this page Why a logo doesn't break the code How big can the logo be? Rules for logo QR codes Which logo file to use Questions
In short
  • Use error correction H.
  • Keep the logo under about 25% of the code width.
  • Never cover the three corner squares.

Why a logo doesn't break the code

QR codes store extra recovery data, called error correction. If part of the code is missing, scanners use that extra data to rebuild it. A logo is simply a hole you choose to make on purpose.

At level H, a code can recover roughly 30% of its data. But the logo isn't the only thing using that budget: blur, glare and scratches use it too. So treat 30% as the absolute ceiling, not the target.

Open the generator, then add your logo in the Logo tab. Error correction switches to H automatically.

Add my logo

How big can the logo be?

Logo width (share of code width)Share of the code coveredVerdict
15–20%2–4%Safe almost anywhere
20–25%4–6%Safe with error correction H
25–32%6–10%Fine on screens; test carefully in print
Over 35%12%+Often fails

The cleared space around the logo counts too. The generator's "Clear dots around logo" option makes a clean edge, which looks better and helps scanners, at the cost of a slightly bigger hole.

Logo width as a share of the code width. Error correction H gives the logo room. Labels describe printed, real-world scanning; a clean screen is much more forgiving.

Rules for logo QR codes

  1. Use error correction H. QRaft switches to H as soon as you add a logo.
  2. Center it. Never cover the three large corner squares; scanners use them to find the code.
  3. Give it a backing. A plain plate behind a busy logo stops it blending into the dots.
  4. Keep contrast high elsewhere. A logo plus low-contrast colors plus fancy dots is where codes start failing.
  5. Go bigger in print. Error correction H adds more dots, so print the code a little larger than a plain one.

Which logo file to use

A square PNG or SVG with a transparent background works best. Simple marks, such as an icon or monogram, read better at small sizes than a full wordmark.

Questions

Does a logo make a QR code harder to scan?

A little. A small centered logo with error correction H scans reliably; large logos or logos combined with low contrast cause failures.

What error correction should I use with a logo?

Level H, which recovers about 30% of the data.

Can I put the logo somewhere other than the center?

It's possible, but the center is safest. Never cover the three corner squares.