Guides / Print and packaging

Engraved and laser-etched QR codes

Engraving gives permanent codes, but contrast is lower than ink and depends on the material. Make modules bigger than in print, use error correction H, and check whether your material produces a dark or a light mark.

2 min readPrint and packaging
On this page Dark mark or light mark? Size and settings Test on scrap first Questions
In short
  • Know whether the mark comes out dark or light.
  • Modules of 0.5 mm or more, error correction H.
  • Matte surfaces scan better than polished ones.

Dark mark or light mark?

Some materials go darker where the laser hits; others go lighter. If your engraving is lighter than the surface, the result is an inverted code, which some scanners can't read. You can invert the artwork before engraving so the final code comes out dark on light.

MaterialTypical markNotes
WoodDark on lightGood contrast; grain adds noise, so go larger
Black anodized aluminumLight on darkVery crisp; invert the artwork for a normal code
Bare stainless steelDark (with marking spray or annealing)Polished steel reflects light; matte finish helps
GlassFrosted (light)Needs a dark backing behind the glass
PlasticsVaries by plasticTest first; some foam or discolor
Inverted codes look striking, but not every scanner can read them. Labels describe printed, real-world scanning; a clean screen is much more forgiving.

Size and settings

Make a code with square dots and error correction H, then export SVG for your laser software.

Make an engraving file

Test on scrap first

Engrave a test on an offcut of the same material, scan it under normal lighting and at an angle, then adjust power and speed. Polished metal often scans better when tilted slightly to avoid direct reflection.

For tiny industrial parts, manufacturers often use Data Matrix codes instead of QR codes, which hold data in less space. For anything a consumer will scan with a phone, QR is the better choice.

Questions

Can you laser engrave a QR code?

Yes. Use modules of at least 0.5 mm, error correction H, and test on scrap material first.

Why won't my engraved QR code scan?

Usually low contrast, a reflective surface, or a light-on-dark mark that some scanners can't read. Invert the artwork or add contrast.